MICCROSTOP is suitable for use in the following cycles:
High-Speed Copper Tin
Chrome (Decorative) Zinc
Phosphate Coatings Gold
Alloy Coatings Silver
Heavy Deposit Industrial Chrome
Nickel, Cadmium, Gold on Silver, Silver on Gold
APPLICATION PROCEDURE
1. Chemically and/or mechanically clean the area of the part to be masked. The area to be masked must be free of all dirt, grease, oil or other contaminants. Cleaning is the most critical aspect of the masking procedure.
Apply MICCROSTOP to the area to be masked by dipping, brushing, or spraying. Appropriate dilution of MICCROSTOP is required for spraying. For reducing MICCROSTOP, use MICCROSTOP REDUCER only.
Apply a minimum of two successive coats of MICCROSTOP to the area to be masked, allowing a minimum of 30 minutes air-dry time between coats and overnight air-dry time after final coat before introduction into solution. Faster drying of MICCROSTOP can be accomplished by force drying for 15 minutes in an oven not exceeding 140_ F, or over a hot plate not exceeding 140_ F. Drying time will vary according to relative humidity. NOTE: Make sure MICCROSTOP has lost all solvent odor before force drying or applying additional coats.
For extra long cycles, 3 coats are recommended.
5. MICCROSTOP can be removed using MICCROSTOP REDUCER or MiCCROSTRIP A.
CHARACTERISTICS
Color:
Transparent Red
Viscosity: 32-37 sec #2 Zahn
Coverage Rate: Approx. 500 ft.2 (46 m2) per gallon,
1.0 mil dry film.
WtJGal.: 7.50 Ibs./gal.
Flash Point: 24_ F. TCC
MICCROSTOP is available in: 1 gal., 5 gal., and 55 gal. containers.
Developed and manufactured by experienced platers and coalers
PRECAUTIONARY INFORMATION
CONTAINS VOLATILE SOLVENTS _ Keep away from sparks and open flame. Store at temperatures above 32_ F and below 105_ F. Keep containers closed when not in use. Maintaln adequate ventilation in working area. Wear approved respirators and protective clothing when working in confined areas. Avoid repeated breathing of concentrated vapors. Prolonged contact of liquid material with skin may be irritating. If material comes in contact with skin, wash skin surface thoroughly with soap and water. In case of eye contact, flush eyes thoroughly for 15 minutes with water and consult a physician. REFER TO MATERIAL SAFETY DATA SHEET FOR ADDITIONAL WARNINGS AND INFORMATION.
Other products in the category Chemicals for Special Applications / Plating:
Anodes Zinc Metal Balls 99%+ 50 Lb Box -- NEW CUSTOMERS (CALL, EMAIL or QUOTE) for PRICE
Antifoam(tm) 1410 40 Lb Pail -- NEW CUSTOMERS (CALL, EMAIL or QUOTE) for PRICE
Antifoam(tm) 1410 441 Lb Drum -- NEW CUSTOMERS (CALL, EMAIL or QUOTE) for PRICE
Cadmium Oxide Technical Grade 50 Lbs Pail HAZMAT -- NEW CUSTOMERS (CALL, EMAIL or QUOTE) for PRICE
Chrome Etch Type 1020 1Gal Bottle HAZMAT C51020 -- NEW CUSTOMERS (CALL, EMAIL or QUOTE) for PRICE
MICCRO SH-110 VOC FREE 1 Gal Can
MICCRO SUPER XP-2000 STOP-OFF LACQUER 1 Gal Can
MICCRO SUPER XP-2000 STOP-OFF LACQUER 5 Gal Can
MICCROMASK STOP-OFF LACQUER 1 Gal Can
MICCROMASK STOP-OFF LACQUER 5 Gal Can
MICCROPATCH MC-753 AIR DRY PATCH FOR PLASTISOL COATINGS BLACK 1 Gal Can
MICCROPATCH MC-753 AIR DRY PATCH FOR PLASTISOL COATINGS BLACK 5 Gal Can
MICCROPEEL LACQUER 1 Gal Can
MICCROSHIELD STOP-OFF LACQUER 1 GAL Can GCI# MS5901 Tolber HAZMAT
MICCROSHIELD STOP-OFF LACQUER 5 Gal Can
MICCROSHIELD STOP-PEEL REDUCER 1 Gal Can
MICCROSHIELD STOP-PEEL REDUCER 5 Gal Can
MICCROSTOP STOP-OFF LACQUER 5 Gal Can
MICCROSTRIP "A" 1 Gal Can
MICCROSTRIP "A" 5 Gal Can
MICCROTAPE # 1210, 1in 1 Each Roll
MICCROTAPE 3/4" BLACK 1 Each Roll HAZMAT
MICCROTAPE CEMENT 1 Gal Can
MICCROTEX LACQUER 1 Gal Can
MICCROTEX/MICCROPATCH REDUCER 1 Gal Can
MICRO XP-2000 LR LACQUER 1 Gal Can
PLASTISOL BLACK 1 Gal Can -- Product Specs
PLASTISOL BLACK 5 Gal Can -- Product Specs
PLASTISOL ORANGE 1 Gal Can -- Product Specs
PLASTISOL ORANGE 5 Gal Can -- Product Specs
SUPER XP-2000 REDUCER 1 Gal Can
T-100 PLASTISOL PRIMER 1 Gal Can
T-100 PLASTISOL PRIMER 5 Gal Can
T-100 PLASTISOL PRIMER REDUCER 1 Gal Can -- Please reference Part # M59011 when ordering
T-100 PLASTISOL PRIMER REDUCER 5 Gal Can -- Please reference Part # M59111 when ordering
XP-420 LVOC L.R. 5 Gal Can
|
|
|||||||||||||
|
|||||||||||||